Every Single CalculatorOne place for every calculator

Speeds and feeds calculator

Enter the cutting speed for the material, the tool diameter and the chip load to find the spindle speed and feed.

Example: You are about to drill half inch holes in steel plate on the mill and want the right spindle speed.

Your numbers

Cutting speed in surface feet per minute comes from the tool maker's chart for your material.

SFM
in
in
  • Spindle speed0
  • Feed rate0

How it is worked out

RPM = cutting speed × 12 ÷ (3.1416 × diameter), often written as SFM × 3.82 ÷ diameter

Feed = RPM × flutes × chip load

A worked example

A ½ inch two-flute end mill in mild steel at 100 SFM turns at 764 RPM. At 0.002 inches per tooth it feeds at about 3.1 inches a minute.

Good to know

  • Start at the low end of the chart and work up. Rigid setups can run faster than a light machine.
  • Smaller tools need higher RPM for the same cutting speed.
  • For a lathe, use the diameter of the work in place of the tool.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: machinists.