Every Single CalculatorOne place for every calculator

Gravel calculator

Enter the size of the area and how deep the material will be to find how many cubic yards and tons to order.

Example: You are putting 4 inches of base under a 20 by 10 parking pad and the quarry sells by the ton.

Your numbers

Suppliers sell by the cubic yard or by the ton. The weight of a yard depends on the material: gravel is about 1.4 tons, sand about 1.35 and topsoil about 1.1.

ft
ft
in
4 for a driveway base, 2 for a path.
Ask your supplier for their figure.
%
Drawn from your numbers. It redraws as you type.
  • Order0
  • Weight0
  • Volume0
  • Area covered0

Gravel calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the amount is worked out

Multiply length by width by depth, with the depth converted to feet, to get cubic feet. Divide by 27 for cubic yards, then multiply by the weight of a yard for tons.

Cubic yards = length × width × (depth ÷ 12) ÷ 27

Tons = cubic yards × tons per cubic yard

A worked example

A 20 by 10 foot parking pad with 4 inches of gravel is 66.7 cubic feet. Adding 10% for compaction brings it to 73.3 cubic feet, or 2.72 cubic yards. At 1.4 tons per yard that is 3.8 tons.

Good to know

  • Crushed stone packs down when compacted, which is why the calculator adds 10%. Loose decorative gravel needs less.
  • Weights vary with the type of stone and how wet it is. Use your supplier's tons-per-yard figure if they give one.
  • A driveway usually gets 4 to 6 inches of compacted base. Paths and patios get 2 to 4.
  • Lay landscape fabric under decorative gravel to stop it sinking into the soil.
  • A small pickup carries roughly half a yard to a yard of gravel by weight. Check your truck's payload before loading.

Common questions

How much does a cubic yard of gravel cover?

At 4 inches deep, about 81 square feet. At 2 inches deep, about 162.

Can I use this for sand or topsoil?

Yes. The volume is the same. Change the tons per cubic yard to about 1.35 for sand or 1.1 for topsoil.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: concrete contractors, masons, landscapers, excavation and grading, paving and sealcoating, farm and ranch, homeowners.