How the area is worked out
Add up the flat area of every section, then multiply by the pitch multiplier to allow for the slope.
Roof area = (sum of length × width) × √(1 + (pitch ÷ 12)²)
A worked example
A main roof 40 by 30 feet and a garage wing 20 by 16 feet cover 1,520 square feet on the flat. At 6/12 the multiplier is 1.118, so the roof is 1,699 square feet. With 10% waste that is 18.7 squares, or 57 bundles.
Good to know
- Where two sections overlap, such as a wing that runs under the main roof, count the overlap once.
- If sections have different pitches, run the calculator once for each pitch and add the results.
- Valleys, hips and dormers waste shingles. Use 15% on a cut-up roof.
Common questions
Can I measure from a satellite photo?
Yes. A satellite view shows the roof on the flat, which is exactly what this calculator wants. Measure each rectangle and enter the pitch.
How we know this calculator is right
Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.