Every Single CalculatorOne place for every calculator

Board and batten calculator

Enter the width of the wall, the width of your battens and roughly how far apart you want them. The calculator finds the count and the exact gap that makes them come out even.

Example: You are building an accent wall 12 feet wide and want the battens evenly spaced with one at each end.

Your numbers

The layout puts a batten at each end of the wall. Spacing is the clear gap between battens, not center to center.

in
in
A 1x3 is 2½ inches.
in
  • Battens0
  • Gap between battens0
  • Center to center0

Board and batten calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the spacing is worked out

With a batten at each end, there is one fewer gap than there are battens. The calculator picks the number of battens that gets closest to the spacing you asked for, then spreads them evenly.

Gap = (wall width − battens × batten width) ÷ (battens − 1)

A worked example

A wall 144 inches wide with 2½ inch battens and a target of about 16 inches takes 9 battens. They use 22½ inches, leaving 121½ inches for 8 gaps, which is 15 3/16 inches each.

Good to know

  • Cut a spacer block to the gap width. It is quicker and more accurate than measuring each batten.
  • Check where outlets, switches and windows fall before you fix anything. Nudging the spacing by a fraction can keep a batten off a switch plate.
  • Each batten is the height of the wall section, less the top rail and baseboard. Multiply by the count to get the length of trim to buy.
  • Walls are rarely plumb or flat. Set each batten with a level, not by measuring from the corner.

Common questions

What spacing looks right?

Twelve to twenty inches is typical for an interior accent wall. Exterior board and batten siding usually has battens every 12 or 16 inches to cover the board joints.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: finish carpenters, siding and gutter installers.